Instruction manual

25
MAGAZINE DISASSEMBLY
3
5
1
4
2
Slide Block
Forward
Push Up
Remove
Button
Remove Spring
& Plunger
Remove Follower
DAMAGED, NON-STANDARD, OR IMPROPERLY
ASSEMBLED MAGAZINES SHOULD NOT BE USED.
THEY CAN CAUSE THE PISTOL TO MALFUNCTION.
CARE AND CLEANING
Make Sure Gun is Unloaded!
Before cleaning, be certain the pistol and its magazine contain no cartridges (See
“To Unload”, p. 16).
At regular intervals, or whenever the pistol has been exposed to sand, dust,
extreme humidity, condensation, immersion in water, or other adverse
conditions, disassemble, clean, and oil it. Proper periodic maintenance is
essential to the reliable functioning of any firearm.
To clean the pistol, proceed as follows;
1. Disassemble (field-strip) the pistol to the extent described on page 20.
2. Using a cleaning rod, run a solvent-wetted patch through the bore several
times. Then attach a solvent-wetted bristle brush to the rod and run it back
and forth the full length of the bore as many times as necessary to remove
grease and dirt from the bore and chamber. Clean bore with dry patches and
examine. Bore fouling can contribute to reduced accuracy, and grease
accumulation in the chamber can interfere with proper feeding of cartridges
from the magazine.