Instruction manual

21
4. Point muzzle up and pull trigger. Gravity
will cause the hammer to return to its
cocked position if it became dislodged in
step 3. (See Figure 4).
HAMMER CAN BE
SEEN INSIDE SLOT
6. Point muzzle toward ground. Angle the
rear of the pistol forward and slightly
downward, and pull trigger. Gravity will now
cause the hammer to fall to its uncocked
position. You can see the hammer fall into
this position through the slot in the rear of
the grip frame, and when the hammer falls,
you will hear a “click”. This is essential to all
later reassembly steps. Release trigger. (See
Figure 6).
4
FIRING
PIN STOP
5. Slide bolt (recoil spring
upward) fully into receiver.
NOTE: Before sliding bolt into
receiver, BE CERTAIN that the
firing pin stop (part number
A03500, a small pin) is in the
bolt. Without this pin, the first
time the trigger is pulled on an
assembled pistol, the firing pin
will fly so far forward so as to
irreparably dent the rear end of
the chamber of the barrel,
making the pistol useless. (See
Figure 5).
5
6