Instruction manual

TO UNLOAD

NOTE: This sequence must be followed exactly as spelled out. Failure to do so

can result in the pistol’s chamber becoming unintentionally loaded with a

cartridge.

1. The muzzle of the pistol must be pointing in a safe direction at all times, and

fingers must be outside the trigger guard. If the pistol is cocked, put the safety

on by pushing safety button fully upward.

2. Remove the magazine from the pistol and place it where it will not get

damaged or collect dirt. (REMEMBER that even though the magazine has been

removed, a cartridge remaining in the chamber can still be fired.)

3. Firmly hold pistol in right hand so that the right thumb is directly underneath

the bolt stop. Grasp bolt ears firmly between thumb and forefinger of left hand

and snappily retract the bolt to its rearmost position. As the bolt nears the end

of its retraction, the chambered cartridge should be extracted and ejected.

When the bolt is fully retracted, push upward on bolt stop with thumb, then

allow bolt to move forward slowly until it comes to rest against the bolt stop.

Always visually double check the chamber and the interior area of the receiver

and the magazine-well to be certain there are no cartridges present. Gently

shake the pistol to dislodge any cartridge which may have been ejected into

the magazine-well when the bolt was retracted.

CORRECT UNLOADING SEQUENCE