Service manual

OpenScape Business V1
Sales Information Page 75 04.06.2013
– Furthermore, to guarantee the expected functionality, an on-site test of the connection is
recommended. In particular, interworking with other networking and PBX protocols must be
taken into account.
1.10 Project-specific Releases
– Networked systems with more than 8 nodes or more than 1,000 stations (when using UC Suite
S2)
– Networked systems with more than 32 nodes or more than 1,000 stations (without UC Suite)
– Contact Center in terminal server environments (agents on terminal server)
– Activation of Signaling and Payload Encryption (SPE) for secure calls between OpenStage
telephones.
INFO: Remote access (SSDP) must be configured for project-specific releases.
1.11 Positioning within the SEN Product Portfolio
OpenScape Business combines the best features from the established HiPath 3000 and
OpenScape Office world in a single software solution architecture based on modern and
innovative communication technologies.
The OpenScape Business family provides UC solutions for companies and customers that
typically operate in an environment with up to 350 stations. The maximum number of stations in a
standalone scenario is 500, and the maximum number in networks of multiple sites is up to 1,000
stations.
Companies and clients with typical requirements exceeding 350 stations should be addressed
with the OpenScape Enterprise UC solutions for the mid-market.
1.12 Migration
This section describes the technical migration of HiPath 3000 V9 standalone systems and HiPath
3000 V9 internetworks to OpenScape Business V1.
The following communication systems and internetworks can be migrated:
– HiPath 3000 V9 standalone system
– HiPath 3000 V9 Standalone System with OpenScape Office HX
S2
– HiPath 3000 V9 Internetwork
– HiPath 3000 V9 internetwork with HiPath 5000 RSM
– HiPath 3000 V9 Internetwork with OpenScape Office LX
S2
It is also possible to migrate from HiPath 3000 V7 and HiPath 3000 V8 to OpenScape Business
V1. In such cases, an upgrade to HiPath 3000 V9 must be performed before migrating to
OpenScape Business V1.
INFO: Before a HiPath 3000 V9 system can be migrated to OpenScape Business, the
HiPath 3000 V9 system, including all connected devices, must be fully operational. Only
then can a proper upgrade to OpenScape Business be performed.
If an OpenScape Office HX
S2
is additionally connected to the HiPath 3000 V9 communication
system, this can be upgraded to an external UC Booster Server or to a UC Booster Card
integrated in the OpenScape Business V1 communication system. The choice depends on how
many UC users are required.
The upgrading of a HiPath 3000 V9 communication system occurs by replacing the mainboard,
converting the CDB and subsequently migrating the license.
INFO: All of the steps listed below to install the new hardware are described in detail in the
Hardware Installation chapter of the Service Documentation.
The following points must be observed prior to migration:
– Hardware compatibility check
Please verify whether the existing hardware can still be used. Discontinued components or
devices which are no longer supported must be removed and replaced by their respective
successors if required.