User's Guide

Scope Communications UK Ltd
LTX1 Transmitter User Manual
LTX1MAN Page 2 of 10 Issue 2
PREFACE
Important Installation Information
It is the purchasers’ responsibility to determine the suitability of this equipment and its derivatives
for any given application, Scope cannot give specific advice in this manual, as each use will
require independent evaluation.
Scope has, wherever possible, employed extra safeguards to monitor the system’s performance.
Certain system installations, operational requirements or budgets may, however, limit the
effectiveness of these safeguards. Again, the suitability of the system for any given application
must therefore be decided by the installer and their customer, relative to the application and risk.
Good working practice dictates that a suitable system installation log must be generated, together
with a record of the dates when the system has been manually checked, (with the aid of signal
strength meters etc.) enabling the system performance to be compared with the original
installation data. For UK equipment, Scope has no control of the use and application of the
frequencies issued by OFCOM. Some equipment that is licensed may have greater protection
than other equipment which is operated on a WT Act License Exempt basis. The supply of this
equipment is governed by our standard terms and conditions of sale, which can be found on the
reverse of all order acknowledgements*, proforma invoices*, delivery notes, price lists and
invoices. Alternatively, these can be provided on request.
* Faxed proforma invoices and quotations refer to “conditions available upon request”.
Licence
For the UK, this equipment is intended for use on the 433 and 458 MHz Short Range Device
licence exempt radio frequencies and programming has been restricted to these ranges.
For use in the USA, this equipment will require a licence. Consult your dealer for further advice.
For further technical rules governing the use of this equipment you should obtain the FCC Rules
and Regulations, Title 47 Part 80 to end, including parts 90 and 95 available from the US Gov
Printing Office, GPO Book store, FCC Office or www.fcc.gov/oet/info/rules/ .
The FCC ID for this equipment is: JRNUSAWAVETRACK
Important Safety Information
Scope products are designed to operate safely when installed and used according to general
safety practices. The following requirements should be observed at all times.
Do NOT subject this equipment to:
Mechanical shock
Excessive humidity
Extremes of temperature
Corrosive liquids
This equipment is designed primarily for indoor use in a temperature controlled environment. It
must not be used in classified Hazardous Areas, including areas containing explosive or
flammable vapours. If in doubt, consult your local product dealer for further information.