User Manual

ConneXions CX5 Mains, Multi Port Version
CX5 Issue 2
Page 1 of 14
PREFACE
Important Installation Information
It is the purchasers’ responsibility to determine the suitability of this equipment and its derivatives for
any given application, Scope cannot give specific advice in this manual, as each use will require
independent evaluation.
Scope has, wherever possible, employed extra safeguards or designed optional equipment to further
monitor the system’s performance. Certain system installations, operational requirements or budgets
may, however, limit the effectiveness of these safeguards. Again, the suitability of the system for any
given application must therefore be decided by the installer and their customer, relative to the
application and risk.
Licence
This equipment is cleared for use within the USA under a license assigned to the exclusive importer,
PIPS Holdings Inc. License No. 950415906. Certain restrictions apply in respect of power output and
antenna installations.
Alternative frequencies are available by formal license application (Form 600) via the FCC. These will
not be subject to the same restrictions as the standard assigned license. You should obtain the FCC
Rules and Regulations, Title 47, Part 80 to End, including Parts 90 and 95, available from the US Gov.
Printing Office, GPO Bookstore, FCC Office or www.fcc.gov/oet/info/rules/
Important Safety Information
Scope products are designed to operate safely when installed and used according to general safety
practices. The following requirements should be observed at all times.
Do NOT subject this equipment to:
Mechanical shock
Excessive humidity or moisture
Extremes of temperature
Corrosive liquids
This equipment is designed for indoor use, unless expressly stated otherwise, and must not be used
in classified Hazardous Areas, including areas containing explosive or flammable vapours, unless
express authorization has been given in writing by the manufacturer. If in doubt, consult your local
product dealer for further information.
Do not obstruct any slots or openings in the product. These are provided for ventilation to ensure
reliable operation of the product and to protect it from overheating.
Only use a damp cloth for cleaning (not liquid or aerosol based cleaners), and ensure that any power
is removed from the unit prior to beginning the cleaning operation.
Removal of covers from the equipment must only be undertaken by authorized service personnel,
who must ensure that power is isolated prior to removal.
This equipment must be earthed and must only be connected to a grounded outlet.