User Manual

FAQ:
1. When using this product for the first time, please fully charge the product.
2. The remote video is stuck:
Please select the appropriate resolution according to the network environment.
3. SD card does not save video:
You must format the SD card for the first time.
4. Forget the username or password:
The default password of the camera is 6666. If you forget the username or
password, you can restore the camera to the factory settings and reset the username
and password.
5. Factory reset:
Press the mode button of the camera for about 5 seconds until the camera
restarts.
6. The image is blurry:
Remove the protective film of the lens, if it is still unclear, please rotate the camera
and focus the lens, you can get a clear image after focusing.
7. The APP cannot search and detect the camera or cannot configure the network:
Please confirm that the device is connected normally, and check whether the
permission to use the APP is restricted.
If the APP shows that connection failed, try checking the
following:
A. Common routers are supported. Public routers that require login page
authentication are not supported for the time being.
B. Pay attention to the network name, network password and UID when
configuring.
C. Currently, Chinese Wifi names, passwords and special symbols are not
supported.
D. 5G Wifi is not supported.
E. The device is not online but the red light is always on, indicating that the camera
is successfully connected to the Internet, it may be that the APP permission is not
open, please check whether it is open.
F. If WiFi is in WEP encryption mode, please change to WPA mode.