User guide

2) If the displayed number is 10 digits, press the DIAL and the LCD will
display “DIALING ...”. The selected 10 digit number will be prefixed with a
“1” and dialed automatically.
3) If a prefixed “1” is not desired, press and hold the DIAL key for 2 seconds.
The LCD will display “DIALING...” and the 10 digit number will be dialed
automatically.
4) If the displayed number is 7 digits, no adjustment can be made.
With Local Area Code not programmed (default setting):
1) Press ▲ or ▼ to select the number to be dialed.
2) If the displayed number is 10 digits, press DIAL . The LCD will display
“DIALING...” and the 10-digit number will be dialed automatically.
3) To prefix the 10 digit number with a “1”, press and hold the DIAL key for 2
seconds. The LCD will display “DIALING ...” and a “1” followed by the 10
digit number will be dialed automatically.
4) If the displayed number is 7 digits, no adjustment can be made.
*Note: If necessary, you may reset the user programmable menu options to
the original factory set by disconnecting the telephone line, pressing and
holding the ▼ and DIAL keys simultaneously, connecting the telephone line,
then releasing both keys after 2 seconds. All user options will be set to
defaults and all the contents of Caller ID messages and speed-dial memory
keys will be cleared.
Using a Headset:
A standard telephone headset with a 2.5mm phone plug may be used with the
STC-7003 telephone. To use a headset, plug it into the 2.5mm phone jack
(labeled with a “headset” symbol) located on the left side of the telephone.
When the headset is plugged in, the handset is disconnected and the headset
must be used for speaking and listening. To use the handset again, unplug the
headset from the telephone. When using a headset, the handset hook switch
controls the on-hook or off-hook state of the phone. Remove the handset from
its cradle to take the phone off-hook and place the handset on its cradle to put
the phone on-hook
.
Speed-dial Memory Key Labeling (optional):
1. Obtain a pin, sewing needle, knife blade, or similar pointed tool.
2. Press down on the center speed-dial key. Carefully insert the tool in
between the upper or lower edge of the pressed speed-dial key and its
hole in the faceplate. Pry up on the center of the faceplate and lift upward
to remove the faceplate from the telephone.
3. Remove the transparent key caps from the nine speed-dial keys. Insert
labels of your choice between the keys and the transparent key covers.
4. Orient the faceplate so that the two pins molded on the back of the
faceplate align with the corresponding holes on the telephone body.
Carefully reinstall the faceplate by inserting the four tabs on the faceplate
into the four retaining slots on the telephone body.