User guide

24) Press ▲ or ▼ repeatedly to set the third area code digit (0-9)
25) Press SET to confirm and to select the SET PBX PREFIX menu.
26) Press ▲ or ▼ repeatedly to set the PBX prefix digit (0-9 or none)
27) Press SET to confirm and to select the CALL WAITING? menu.
28) Press ▲ or ▼ repeatedly to set the Caller ID on call waiting feature ON or
OFF. The default mode is ON.
29) Press SET to confirm and to select the SET HOLD MODE menu.
30) Press ▲ or ▼ to select LOCAL or PBX hold mode of hold. The default
mode is PBX.
31) Press SET to confirm and to select the SET FLASH TIME menu. The
default flash time is 600ms.
32) Press ▲ or ▼ to select a flash time of 600MS, 300MS, 100MS.
33) Press SET to confirm and to select the SET PAUSE TIME menu.
34) Press ▲ or ▼ to select a pause time of 2.2S or 3.6S. Default pause time
is 2.2s.
35) Press SET to confirm and exit user options setup.
Placing a call:
1) Lift the handset or press SPKR and listen for a dial tone.
2) Dial the desired telephone number using the keypad. Dialed digits are
displayed on the LCD as the number is dialed. After 15 seconds the dialed
digits will be replaced by the call length timer.
3) To end a call, place the handset on the telephone base unit, or if using the
hands-free speakerphone, press the SPKR key. The call time length will
remain on the display for 5 seconds, and then the display will revert to the
standby display mode.
Placing a call on hold (local hold mode):
a. Using handset/headset: Press HOLD, then place the handset in its
cradle.
b. Using speakerphone: Press HOLD.
Retrieving a held call:
a. Using handset/headset: Lift the handset from its cradle.
b. Using speakerphone: Press SPKR.
Last number redial:
1) Lift the handset or press SPKR and listen for a dial tone.
2) Press RD. The last number dialed will be displayed and dialed
automatically.
Volume Adjustment:
Press VOL repeatedly to adjust the handset/headset volume to the desired
level. One of three levels (low, medium, and high) may be selected. To adjust
the speakerphone volume, slide the control on the right side of telephone.
Speed Dial Memory Key Programming and Dialing:
Programming the One-Touch Speed Dial Keys (M1~M9):
1) Verify that the phone is on-hook, as speed-dial key programming may
only be performed with the telephone on-hook.
2) Remove the faceplate overlay to gain access to the programming keys.
3) Press STORE. “STORE NUMBER” will appear on the display.