Owner`s manual

TOYOTA Scion xB REFERENCE 500CF
Procedure
Issue A 10/05/11 Page | 6
5. Door Speaker Removal and Installation
a. Speaker Removal
Note: Make sure to note speaker connector
orientation then unplug speaker connector. (Fig.
5-1)
1. Use a 5/32" drill bit to remove the three rivets
holding factory speaker. (Fig. 5-2)
Note: Start by applying light drilling pressure
and progressively increase force as necessary
towards the end.
2. After drilling, remove rivet debris inside the
door cavity. (Fig. 5-3) Repeat for remaining
door. Note: Failure to remove debris may
induce noise.
b. Speaker Installation
NOTE: Use the OEM Audio Plus 6.5-inch
woofers for the front doors and the OEM
Audio Plus 5.25-inch coaxial speakers for the
rear doors.
1. Using a rivet tool, install supplied rivet fasteners
to mount OEM Audio Plus speaker and connect
speaker connector. Repeat for remaining
doors. (Fig. 5-4)