Owner`s manual

TOYOTA Scion xB REFERENCE 500CF
Procedure
Issue A 10/05/11 Page | 3
1. Vehicle Preparation
a. Apply parking brake.
b. Disconnect the negative (-) battery cable.
c. Prepare a protective surface to place all vehicle
components on.
2. Installation Prep for Amplifier Assembly
a. Remove the Amplifier Assembly and bracket arm
from the box. (Fig. 2-1)
b. Using a T-25 Torx bit, remove the screw located at
the bottom of the Assembly and install the bracket
arm. (Fig. 2-2)
c. Re-install the screw and tighten.
3. Installation Prep for Subwoofers
a. Using a 5mm hex bit, install the subwoofer brackets
to the subwoofer enclosures. The brackets and
enclosures are marked “A”, “B”, “C”, and “D”.
Install bracket “A” to location “A” on the enclosures,
then “B” to “B”, and so forth. (Fig. 3-1)
4. Initial Vehicle Disassembly
a. Remove Door Panels
1. Disengage the small trim panel behind
the interior door handle using an appropriate
panel tool. (Fig. 4-1)