Owner`s manual

TOYOTA Scion xB REFERENCE 500CF
Procedure
Issue A 10/05/11 Page | 19
4. Make sure that the enclosure is nestled in
place and the holes on both brackets are lining
up with the seat bolt holes in the car.
(Fig. 11-6)
5. Very carefully return the seat back to its
original position – After returning the seat back
in place, confirm that the seat bolt holes are
lining up. (Fig. 11-7)
6. Tighten the seat bolts by hand at first to ensure
proper alignment. If there is too much
resistance, start over again and double check
the alignment.
7. Finish tightening all four seat bolts using your
14mm socket and ratchet. (Fig. 11-8)
8. Install the trim covers for the rear seat bolts.
(Fig. 11-9)
9. Re-install carpet, kick panel cover, and
threshold trim in reverse order.