Owner`s manual

TOYOTA Scion xB REFERENCE 500CF

Procedure

Issue A 10/05/11 Page | 16

4. Line up each bracket arm to their

corresponding mounting positions. (Fig. 9-5)

5. Upper Short Arm to 10mm bolt location

6. Lower Long Arm to 12mm bolt location

7. Turn the bolt by hand initially. If binding occurs

remove the bolt and repeats steps.

8. Use socket wrench to tighten. Note:

It may

help to push the lower arm towards the firewall

while installing the 12mm bolt.

c. Connect the Quick-Sync Harness into the Radio and

factory harness using the designated connectors.

(Fig. 9-6)

d. Re-install radio, trim panels, and glove box in

reverse order. Note: Refer to Pg 7, Step 7, Section

10. Loosen Driver and Passenger Seat

a. Slide the seats forward and remove the trim panels

covering the seat bolts on the rear side of the

seats. Locate the slots in the trim covers and pry

them off using the forked end of your trim tool.

(Fig. 10-1)

b. Using a 14mm socket with a 6” extension, remove

the two rear 14mm seat bolts. (Fig. 10-2)