Owner`s manual

TOYOTA Scion xB REFERENCE 500CF
Procedure
Issue A 10/05/11 Page | 15
9. Amplifier Assembly Installation
a. Connecting the DSP and Sub Amplifiers (Fig. 9-1)
1. Plug the White and Gray 22-pin connectors
from the Quick-Sync Harness into their
designated receptacles on the DSP Amplifier.
2. Plug the Black 10-pin connector from the
Quick-Sync Harness into its designated
receptacle on the Sub Amplifier.
3. Plug the 6-pin Gray connector from the Sub
cable into its designated receptacle on the Sub
Amplifier.
4. Repeat steps for the other sub amplifier.
b. Mounting the Amplifier Assembly
1. Remove the outward-facing 10mm bolt used on
the a/c blower unit. (Fig. 9-2)
2. Remove the lower side-facing 12mm bolt off
the black chassis reinforcement bracket
located above the passenger side kick panel.
(Fig. 9-3)
3. Carefully insert Amplifier Assembly through the
bottom opening underneath the glove box
cavity. (Fig. 9-4) Note: Tilt Amplifier Assembly
to the right to clear long mounting arm and slip
into the designated mounting location.