Owner`s manual

TOYOTA Scion xB REFERENCE 500CF
Procedure
Issue A 10/05/11 Page | 12
2. Run power wires to the battery by following the
direction of the factory wiring harness to the
ECU. (Fig. 7-5)
3. Continue in between the ECU and Air Filter Box
and end by the battery. Secure using cable ties
as necessary.
d. Installation of the Fuse Holder
1. Remove the 1:mm bolt from the battery’s
positive terminal and install the ring terminal of
the fuse holder lead. Re-install the 10mm bolt
and tighten. Note: Do not install fuses at this
time! (Fig. 7-6)
2. Connect the power wires to the fuse holder
using the pre-installed butt connectors. Use
wire stripper and strip 3/8" off the end of each
power wire. (Fig. 7-7)
3. Start with the ( larger ) 12 ga. power wire by
inserting it into the Yellow butt connector.
(Fig. 7-8)
Note: Use appropriate Crimp Tool