Owner`s manual

TOYOTA Scion xB REFERENCE 500CF
Procedure
Issue A 10/05/11 Page | 10
3. Install the harness ground together with the
factory ground.
Note: Make sure harness ground terminal
rests on top of the factory ground.
4. Re-install the 10mm bolt and tighten. (Fig. 6-9)
d. Run driver side of Quick-Sync Harness and driver
side subwoofer umbilical cable.
1. Enter through the radio cavity and run the
yellow power wires together with the driver side
subwoofer umbilical cable towards the
accelerator pedal. (Fig. 6-10)
2. Lay the (3) yellow power wires on the floor.
(Fig. 6-11)
3. Finish routing the driver side subwoofer
umbilical cable above the accelerator pedal and
steering column into the driver side kick panel.
Run neatly and out of the way. Use cable ties as
necessary. Leave the extra slack on the floor
for now. (Fig. 6-12)