Owner`s manual

TOYOTA Scion FR-S System 400
Procedure!
Issue A 06/01/12 Page | 9!
! !
!
!
5. Lift the foam support up and fold it over so it
rests on top of the rear seat back rest.
(Fig. 4-15)
6. Disconnect the 10-pin factory amp connector.
(Fig. 4-16)
7. Run the Quick-Sync harness’ amplifier
connectors through the 1”x 2” slot. Pass
through one connector at a time. (Fig. 4-17)
8. Using the factory ground located behind the
rear passenger side trim panel, remove the
10mm ground bolt and install the harness
ground together with the factory ground. Re-
install the 10mm bolt. (Fig. 4-18)
Note: Make sure harness ground terminal
rests on top of the factory ground terminal.