Owner`s manual

TOYOTA Scion FR-S System 400
Procedure!
Issue A 06/01/12 Page | 8!
! !
!
!
d. Route the Quick-Sync Harness
1. Use a utility knife and cut a U-shaped slot
approximately 1” wide and 2” high in the area
located in this picture on the passenger side
trunk panel. This will provide access for the
harness plugs to the amplifiers. (Fig. 4-11)
2. Remove the trunk carpet and trunk floor board.
(Fig. 4-12)
3. Use a plastic panel tool to remove the three
push in snaps securing the foam support
between the back seat and spare tire.
(Fig. 4-13)
4. Use a plastic panel tool and remove the push in
snap on top of the factory amplifier. (Fig. 4-14)