Owner`s manual

TOYOTA Scion FR-S System 400
Procedure!
Issue A 06/01/12 Page | 14!
! !
!
!
2. Return to the driver side under-dash and route
the two yellow power wires through the firewall
grommet (lubricate accordingly to prevent
binding). Run the entire length of power wire
then pull it back one inch and apply a bead of
silicone sealant to the wire. Push the wire with
silicone to seal the opening. (Fig. 6-2)
3. Install the 1/4" corrugated split loom onto to
the power wires. Run the entire length to the
firewall grommet. (Fig. 6-3)
4. Run the loomed power wires across the engine
bay towards the battery. Secure to existing
factory wiring using cable ties. (Fig. 6-4)
NOTE: Run the power wires directly
underneath the windshield wiper cowl.
7. Fuse Holder Assembly Installation
1. Remove the 12mm top nut from the battery’s
positive terminal and install fuse holder ring
terminal. Re-install the 12mm nut and tighten.
Note: Do not install fuses at this time!
(Fig. 7-1)
!