Owner`s manual

TOYOTA Scion FR-S System 400
Procedure!
Issue A 06/01/12 Page | 13!
! !
!
!
4. Install and position the speed clip so that it
aligns with the top hole on the 2-hole bracket.
(Fig. 5-5)
!
5. Place the subwoofer enclosure in position and
install the ¼-20 x 2 ½” hex screw with washer
on the backside to secure the enclosure.
(Shifting the enclosure may be necessary to
align holes). Do not fully tighten yet. (Fig. 5-6)
6. Install the ¼-20 x 1 ½” hex screw with washer
on the front side of the enclosure. (Fig. 5-7)
7. Once Subwoofer enclosure is aligned, secure by
tightening both mounting screws.
6. Power Wire Installation
1. Locate the factory wiring harness grommet (on
the driver side of the engine bay adjacent to the
break master cylinder). Cut-off the tip of the
grommet nipple. (Fig. 6-1)