Owner`s manual

TOYOTA Scion FR-S System 400
Procedure!
Issue A 06/01/12 Page | 10!
! !
!
!
9. Run the ground wire with exiting factory wire
and secure using the provided cable ties.
(Fig. 4-19)
10. Route the harness through the channel
provided under the foam support. (This will
allow the foam support to be re-installed
properly). (Fig. 4-20)
11. Connect the factory male amp connector to the
female connector from the Quick-Sync harness.
(6-pin connector does not need to be plugged).
(Fig. 4-21)
12. Re-install foam support, trunk floor board and
carpet
13. Continue to route the Quick-Sync harness
toward the driver side of the vehicle and secure
to existing factory wires using provided cable
ties. (Fig. 4-22)
14. Reinstall Driver and Passenger side trim panels
and Rear seat cushions.
15.