Unit installation

2008 SCION xB CRANK BOLT REPLACEMENT
& PANEL REMOVAL
Procedure
Issue A: 04/28/08 Page 8 of 48
(f) Leave passenger side plastic body/fender shroud
and fasteners off until the very end of the
installation. This will make it much easier to
install the TRD supplied serpentine belt later on.
You should leave the passenger side front wheel
assembly off as well to install the plastic shroud
after the belt is installed.
(g) Remove the front driver’s side wheel/tire. (Fig.
3
-5)
(h) Partially remove the front driver side fender
liner to expose the area behind the front fascia.
(Fig 3-5)
(1) Remove three push-in clips.
(2) Remove one 10mm screw.
(3) Remove one ¼ turn clip.
(4) Remove two 10mm screws. (Fig. 3-6)
(
5) Remove one push-in clip. (Fig. 3-6)
(6) Remove the clip holding the inlet tube to the
fender. (Fig 3-7)
(7) Leave the wheel off and the inner fender
loose until the TRD air cleaner has been
installed.
10 mm Socket
& small screwdriver
FIG. 3-6