Unit installation

2008 SCION xB CRANK BOLT REPLACEMENT
& PANEL REMOVAL
Procedure
Issue A: 04/28/08 Page 7 of 48
3. Crankshaft Pulley Bolt and Panel Removal.
(a) Remove passenger side front tire/wheel
assembly in order to properly access fender
shroud and crankshaft pulley bolt. (Fig. 3-1)
(
b) Remove passenger side plastic body/fender
shrouds in order to gain access to crankshaft
pulley. (Fig. 3-1 and Fig. 3-2). Use a small
screwdriver to remove the 5 plastic clips.
NOTE: The inner fender lining has been
removed to expose the two forward clips.)
(c) Remove factory crankshaft pulley bolt. Utilize
SST 09213-54015-01 and 09330-00021. (Fig.
3-3). CAUTION: be careful not to damage OE
power steering hard line when working with
crankshaft pulley. See arrow in Fig. (3-4).
(
d) DO NOT remove pulley from the crankshaft!
Remove ONLY the retaining bolt. NOTE: some
crankcase oil may drip out. This is normal.
(e) Clean and coat the threads of the TRD Hi-
Strength 12-Point M14 Bolt with Red Loctite
272 Thread Locking Compound or equivalent.
Install into crankshaft pulley. Using the SSTs
and a 1/2 inch drive TORQUE WRENCH,
Torque to 150 ft-lbs.
Fig. 3
-
3
Fig. 3
-
2
Fig. 3
-
4