Unit installation

SCION xB 2008 VEHICLE PREPARATION
Procedure
Issue A: 04/28/08 Page 5 of 48
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:-
• Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
• Safety (eye protection, rechecking torque procedure, etc.).
• Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
• Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
Please see your Toyota dealer for a copy of this document.
1. Installation review and vehicle preparation.
(a) Review entire installation instructions provided
with this supercharger kit before beginning the
installation.
(b) Review parts list/kit contents to ensure that all
parts are present before beginning the
installation. If any items are missing contact
Technical Support at [phone] before
proceeding.
(c) Remove any low-octane fuel from vehicle.
Ensure that ONLY Premium Unleaded
Gasoline 91 Octane or higher is used.
(Octane Method (R+M)/2). Use EXTREME
CAUTION if draining is necessary.
(d) Place vehicle onto vehicle hoist. Place fender
protection blankets over fenders and front of
vehicle to protect cosmetics of vehicle.
(e) Disconnect Negative Battery Terminal (-
--
-).
(10mm wrench) Then disconnect battery
positive terminal. Remove battery hold down
strap. Remove battery and plastic tray from
engine compartment. (Caution: Batteries
contain an acid solution, be sure to wear eye
protection and gloves when handling the
battery. Place battery onto workbench until
replacement later. Do not the place battery on
cement or concrete floors.)
12 mm Wrench