Unit installation

2008 SCION xB FINAL ASSEMBLY
Procedure
Issue A: 04/28/08 Page 42 of 48
(e) Replace engine cover. Torque to 62 in-lbs.
Verify engine cover to drive belt clearance,
adjust as necessary. (Fig 20-3)
(f) Select a suitable location under the vehicle hood
and install the Belt Routing Label, the CARB
EO Emissions Compliant Label, and the TRD
Tune-Up Label. Clean the area first of any dirt
or contamination so that the labels will adhere
properly. NOTE: Do NOT cover over any OE
labels.
(g) Install Premium Fuel Only decals. Place one
on dash near fuel gage AND also one near fuel
filler cap.
(h) Connect Battery Positive. Be sure to route
Battery (+) cable safely away from engine
components, supercharger components,
abrasive surfaces, and any sharp objects.
(i) Connect Battery Negative.
10 mm socket
Fig 20
-
3