Unit installation

2008 SCION xB FINAL ASSEMBLY
Procedure
Issue A: 04/28/08 Page 41 of 48
20. Final Assembly
(a) Be sure both coolant system drain cocks are
closed. Engine block drain cock should be
torqued to 9 ft-lbs. Pour any remaining OE
coolant back into radiator filler mouth. Use
only Toyota Super Long Life Coolant or
equivalent. Fill system up with coolant/water
mix (approximately 50-50). Close bleeder port
when done. Cap radiator. Wipe up any spilled
or excess coolant.
(b) Install TRD Supercharger Serpentine Drive
Belt. As before, utilize SST 09249-63010
leverage tool with 19mm, 6-point socket and
lever arm, or ratchet. (Fig 20-1)
TRD Part Number: PTR30-21070
Note: BE SURE that the belt is properly
seated into ALL of the pulleys.
(c) Reinstall passenger side inner fender panels and
tire/wheel assembly. Refer to figures on page 7.
(d) ADD ENGINE OIL!!! Use SAE 5W-30, 4
U.S. Quarts minimum. Check oil level on
engine dipstick. Add oil as needed.
*
*IMPORTANT: DO NOT overfill the
engine with oil. Excessive oil fill level may
cause supercharger seal and engine damage.
Fig. 20-1