Unit installation

2008 SCION xB AIR INLET AND DISCHARGE
INSTALLATION
Procedure
Issue A: 04/28/08 Page 32 of 48
(e) Install O.E. valve cover breather hose and O.E.
clamp onto cast aluminum TRD intake
manifold. Install intake with bypass hose to
bypass valve. Do not tighten hose clamps yet.
(Fig. 18-4).
(
f) Fit TRD inlet manifold to supercharger. NOTE:
Use a small amount of motor oil or equivalent to
lubricate the intake bore and O-ring surface
interface prior to assembly. Be sure to align
manifold so that all hoses are free from kinks
and away from any sharp edges. (Fig 18-5).
(g) Utilizing the 3 TRD supplied 6 x 1.0 x 16mm
SHCS and three 6 mm flat washers, clamp down
TRD inlet manifold to supercharger assembly.
5 mm Allen wrench. (Fig. 18-5). T
orque to
15 inch-lbs.
(h) Install valve cover breather hose onto valve
cover. Be sure hose is not kinked. Re-adjust as
necessary. (Fig. 18-6).
Fig. 18
-
6
Fig. 18
-
4
Fig. 18
-
5