Unit installation

SCION xB 2008 SUPERCHARGER
Preparation
Issue A: 04/28/08 Page 3 of 48
Addtional Items Required For Installation
Item # Description NOTES
1 A/T Sub Kit, PTR41-
52091
Transmission Dipstick
Tube, S/C Spacers
Recommended Tools
Personal & Vehicle
Protection
Notes
Safety Glasses ANSI Z-71 or better
Fender Blankets Non-Marring
Protective Gloves Gasoline and Brake Fluid
Resistant
Special Tools Notes
Toyota TIS Techstream
Version 2.20.015 or later
Battery Charger
Serpentine Belt tool
09249-63010
Crankshaft Pulley Holder
09213-54015-01
Pulley Holder Lever Arm
09330-00021
Gasket Seal Cutter
09032-00100
Oil Filter Wrench
09228-06501 or equivalent
Installation Tools Notes
Mechanic’s Hand Tools
Wrenches, Sockets and Hex
(Allen) Keys
Metric AND Standard
½” Torque Wrench-150ft/lb For crank pulley bolt install
19 mm 12-point socket ½”
drive
For crank pulley bolt install
Special Chemicals Notes
Anti-Seize Assembly Lube For Spark Plugs
Toyota Seal Packing (FIPG)
08826-00080 or 00295-
00102 or 00295-00103
Or equivalent for oil pan
reinstallation.
Loctite 242 Blue Threadlock Or equivalent
Loctite 567PST Teflon Paste Or equivalent
General Applicability
(2008) Scion xB (2AZ-FE – 2.4L I4)
Recommended Sequence of Application
Item # Accessory
1 Instruction Review, Vehicle Preparation
2 R&R Oil Pan, Crank Bolt
3 Remove OE Intake System and Area
4 Prepare Engine
5 Install Supercharger
6 Install TRD Intake System
7 Re-Flash ECU with TRD Map
8 Test
*All Sequences Are Mandatory
Vehicle Service Parts (required for reassembly)
Item # Quantity Reqd. Description
1 1 Oil Filter , 90915-YZZF1
2 1 Oil Drain Gasket 90430-12031
3 4.0 ~ 4.8 Quarts Oil, SAE 5W-30
4 1 roll Black Electrical Tape, 600 V
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION:
A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT:
Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.