Unit installation

2008 SCION xB CLUTCH CYLINDER RE-ASSEMBLY
Procedure
Issue A: 04/28/08 Page 27 of 48
15. Clutch Cylinder Re-Assembly (steps 15a.-15g.
apply to manual transmission vehicles ONLY)
(a) Bolt the accumulator/TRD bracket assembly to
the clutch slave studs, re-using the 2 nuts
removed. Torque to 16ft-lbs (Fig. 15-1, shown
o
ut of vehicle for clarity only).
(b) Use one of the heat shield bolts, two M6 screws
and the TRD accumulator heat shield to
complete the installation of the accumulator
bracket to the slave cylinder. (10mm & 12mm
sockets) Torque to 80 in-lbs (10mm) & 16ft-
lbs. (12mm) (Fig. 15-2, shown out of vehicle for
clarity only).
(c) Install the new clutch hard line from the clutch
accumulator to the clutch slave cylinder and
tighten. (Fig. 15-2)
(d) Attach the clutch hard line to the accumulator
inlet. Leave loose for now.
(e) Using the supplied bolt and spacer, re-attach the
clutch hard line to the transmission and secure.
(10mm socket) Torque to 16ft-lbs. (Fig. 15-3)
(
f) Tighten the hard clutch line to the accumulator,
and tighten the hard line to flex line bracket.
Torque to 16ft-lbs.
(g) Bleed the clutch hydraulic system as per the
Repair Manual. With another person operating
the clutch pedal, visually inspect the clutch
accumulator/slave area for leaks.