Unit installation

2008 SCION xB SUPERCHARGER INSTALLATION
Procedure
Issue A: 04/28/08 Page 26 of 48
Note: Only perform the following alignment
steps if a bolt and hole alignment or binding
issue is observed.
*Alignment Procedure:
Leave the rear
mounting bolts in the supercharger and
transmission installed, but loose to maintain
bracket alignment. Temporarily loosen the
three bracket fasteners a few revolutions, as
shown in Fig. 14-7. 6mm Allen wrench. Do
NOT take the bolts out of their respective
holes. Line up the alternator pivot bolt and
thread in a few turns. Re-tighten the 3 bracket
fasteners Fig 14-7. (NOTE: A wobble drive
Allen wrench may be the preferred tool here.)
Then tighten the Alternator pivot bolt, then the
front bracket bolt to cylinder head, then last, the
supercharger rear bracket bolts.
Fig. 14
-
7
6 mm
Allen