Unit installation

2008 SCION xB ENGINE PREP. DRIVE BELT SIDE
Procedure
Issue A: 04/28/08 Page 20 of 48
11. Engine Preparation: Drive Belt Side.
(a) Remove factory serpentine drive belt. Utilize
SST 09249-63010 leverage tool with 19mm, 6-
point socket and lever arm or ratchet. (See Fig
11-1). The tensioner moves slowly. While
a
pplying medium tension, allow the tensioner to
“float” forward. CAUTION: Applying too
much tension or forcing the tensioner can cause
the assembly to break.
(b) Using a small flat blade tool, remove the plastic
retainer clip from the wire harness on the
alternator. Remove and discard the harness
bracket attached to the top of the alternator.
Retain the fastener for reuse later. (Fig. 11-2).
(c) Disconnect Alternator wiring. (See Fig 11-2).
(d) Add TRD-supplied CPS extension wire to
connector on the engine.
(e) Loosen, but do not remove, the CPS connector
bracket from engine (10mm wrench) figure 11-
3. Rotate the bracket toward the engine so the
c
onnector is facing up at the 12 o’clock
position. Allow slight clearance between the
engine and the connector. Tighten metal
bracket while holding the bracket in place.
Torque to 80 in-lbs.
(f) Remove alternator pivot bolt see figure 11-3.&
11-4 (14mm Socket).
Fig. 11
-
1
Fig. 11-2