Unit installation

2008 SCION xB ENGINE PREP. DRIVE BELT SIDE
Procedure
Issue A: 04/28/08 Page 19 of 48
(g) Remove the 4 bolts holding the clutch
accumulator to the accumulator bracket. (See
Fig 10-4). (10mm Wrench) C
AUTION: Make
sure the ring on the back side of the
accumulator does not fall out. (See Fig 10-5).
Fluid will leak out during use if the ring is not
in place when reinstalled.
(h) Replace the accumulator bracket with the TRD
supplied bracket (See Fig 10-6). Torque the
four bolts to 80in-lbs. (10mm socket)
(i) Cover all open lines and ports. The clutch
accumulator assembly will be re-installed after
the supercharger unit is installed. Set this
assembly aside for now.