Unit installation

2008 SCION xB ENGINE PREP. DRIVE BELT SIDE
Procedure
Issue A: 04/28/08 Page 18 of 48
Auto Transmission: Skip this step and
proceed to step 11.
10. Clutch Cylinder – Manual Transmission Only
CAUTION: The following steps will cause a
leakage of brake fluid. Use appropriate
personal protection gear (gloves and safety
glasses) to avoid personal injury. When
completed, remove any residual brake fluid
from painted surfaces with water as brake
fluid can damage painted surfaces. Do not
allow water to get into the brake system!
(a) Place a line clamp on the soft clutch slave feed
line to prevent unnecessary loss of brake fluid
first.
(b) Remove the heat shield from the accumulator
using a 12mm socket. Save the bolts. The
shield will NOT be re-used. (See Fig 10-1).
(
c) Remove the clutch hard line clamp on the
transmission, leaving the bracket attached to the
line (10 mm socket). Loosen the remaining line
bracket (where the hard and soft lines connect),
but leave attached to the transmission (12 mm
socket). (See Fig 10-2).
(
d) Disconnect the hard clutch line between the
transmission and the accumulator inlet. (See Fig
10-2).
(e) Remove the clutch hard line between the slave
cylinder and accumulator outlet. (See Fig 10-3).
(f) Remove the 2 nuts holding the accumulator and
bracket to the clutch slave cylinder (12mm
Socket). (See Fig 10-3).
FIG. 7-1