Unit installation

2008 SCION xB OIL PRESSURE ADAPTER
Procedure
Issue A: 04/28/08 Page 15 of 48
8. Oil Pressure Switch Adapter Installation
(a) Rotate radio noise suppressor up at
approximately a 45 degree angle. (Fig. 8-1).
(
b) Unplug oil pressure switch. Remove OE oil
pressure sending unit. Use a deep 24 mm (or
15/16”) socket to remove. (Fig. 8-2).
(c) Locate the TRD supplied hexagonal T fitting.
Place a small amount of Teflon paste onto the
threads and insert. (Torque to 11-ft-lbs).
NOTE: The female threads need to be pointing
upwards within about +/- 10 degrees from the
1:00 O ’Clock position. You will need a 7/8
inch wrench. (Fig. 8-3)
(
d) Place a small amount of Teflon paste onto
threads and thread in OE Oil Pressure Switch
into the top of TRD hexagonal T fitting.
(Torque to 11-ft-lbs). Reconnect electrical
connector. (Fig. 8-4). Be sure that the wires are
in a relaxed, strain-free position.
Fig. 8
-
1
7/8”
Fig. 8
-
3
Fig. 8
-
4
24mm
Fig. 8
-
2
24mm