Unit installation

2008 SCION xB O.E. INTAKE REMOVAL
Procedure
Issue A: 04/28/08 Page 10 of 48
5. Engine Preparation: Intake System and Area.
(a) Disconnect Air Fuel Ratio (AFR) Sensor at the
electrical connector (Fig 5-1).
(b) Unplug the Mass Air Flow Sensor harness
connector. Remove wire harness from the air
cleaner lid. Remove the two screws holding the
sensor in place. Remove the sensor from the air
cleaner lid. CAUTION: Be careful not to drop
or damage the sensor. (Fig. 5-2)
(
c) Loosen the air inlet hose clamp (10mm). (Fig.
5
-3)
(d) Unfasten the 3 hook clamps. (Fig. 5-3)
(e) Remove the air cleaner lid and air filter.
Fig. 5
-
1
Phillips
Screwdriver
10 mm
Fig. 5-2
Fig. 5-3