Owner`s manual

SCION tC 2007 - SECURITY (V5)
Procedure
Page 21 of 28 pages
Issue: B 02/27/06
(d) Connect the V5 harness’ 40P connector to
the V5 ECU and 8P connector to the GBS
ECU.
(e) Locate the two holes in the brace to the right
side of the glove box area. Secure the V5
ECU and GBS ECU to the outside of the
brace with two bolts supplied in kit.
(Fig. 8-4)
(1) Verify the bolts are tightened and
secured.
(f) Locate the V5 harness’ black taping, and the
white and gray connectors harness’ black
taping in the right side of the glove box area.
Match those tapings and secure with one
wire tie. (Fig. 8-4)
9. Warning Label Installation.
(a) Clean the inside surface of the front door’s
windows. (Fig. 9-1)
(b) Place the warning label on the inside surface
of the front door’s windows as shown.
(Fig. 9-1)
(1) Use a piece of clean adhesive tape to lift
the labels off their protective backing
sheet.
(2) Do not touch the adhesive surface of the
warning labels.
Fig. 9-1
Warning Label
10mm
Line up with bottom
of window etching
Fig. 8-4
10mm Socket
,
Side Cutte
r
V5 ECU and GBS
Bolts (x2)
Wire Tie
V5 Harness
Brace