Owner`s manual

SCION tC 2007 - SECURITY (V5)
Procedure
Page 17 of 28 pages
Issue: B 02/27/06
(b) Connect the V5 harness’ black 4P connector
to the status monitor 4P connector.
(Fig. 5-2)
(1) Verify the connectors are plugged in
securely.
(c) Refit the cluster panel. (Fig. 5-2)
6. V5 Wire Harness Installation.
(From Steering Area to Center Console Area)
(a) Route the V5 harness toward the center
console area. (Fig. 6-1)
(1) Route the V5 harness through the
opening space in front of the driver side
brace as shown.
(b) In the center console area, locate the white
40P connector’s ORANGE wire (bottom
row, sixteenth space from the left). Attach
the V5 harness’ ORANGE wire with a
splicing connector. (Fig. 6-2)
(1) Turn the connector so the wires face you
and the tab is on top.
(2) Verify the correct wire is chosen for
splicing.
(3) Verify the splicing connector is applied
properly.
(c) Locate the tape on the vehicle harness’ 40P
connector wires, then match it with the V5
harness’ white taping. Secure the harnesses
with one wire tie at the taping. (Fig. 6-2)
Fig. 5-2
Cluster Panel
V5 Harness’
Black 4P
V5 Harness
Fig. 6-2
Wire Side View
40P
V5 Harness’
White Tape
Side Cutter
Pliers
40P
Splicing Connector
V5 Harness
Wire Tie
V5 Harness’ ORANGE Wire
ORANGE
Fig. 6-1
V5 Harness
Brace
Vehicle Harness
V5 Harness