Owner`s manual

SCION tC 2007 - SECURITY (V5)
Procedure
Page 14 of 28 pages
Issue: B 02/27/06
(i) Insert the terminal at the end of the V5
harness’ VIOLET wire into the top row, nine
spaces from the left of the vehicle’s harness
30P connector. (Fig. 4-7)
(j) Insert the terminal at the end of the V5
harness’ ORANGE wire into the bottom row,
ten spaces from the left of the vehicle harness
30P connector. (Fig. 4-7)
(1) Verify the correct wire is chosen.
(2) Verify the terminal is inserted and seated
properly.
(3) The terminal should not come out when
pulled lightly from the back. If it does,
push it in again until securely seated.
(k) Close the long terminal retainer of the 30P
connector. (Fig. 4-7)
(l) Disconnect the empty 2P female connector
plugged into the V5 harness. Using a small
jeweler’s screwdriver, lift the terminal
retainer on the back of the empty connector.
(Fig. 4-8)
(1) Do not pull out the retainer.
Fig. 4-7
Wire Side View
VIOLET
ORANGE
30P
Retainer
V5 Harness’ ORANGE
Wire Terminal
V5 Harness’
VIOLET Wire
Terminal
30P
V5 Harness
Fig. 4-8
Retainer
2P (Female)
2P (Female)
V5 Harness’ 2P
Jeweler’s Screwdriver