Owner`s manual

SCION xA 2006 - SECURITY WITH RKE (V3)
Procedure
Page 14 of 22 pages
Issue: C 05/24/05
DIO
(f) Connect the V3 ECU connectors (8P, 12P,
22P) to the V3 ECU. (Fig. 7-5)
(1) Verify the connectors are plugged in
securely.
(g) Mount the V3 ECU to the glove box area
with the vehicles' bolt. (Fig. 7-6)
(1) Verify the bolt is tightened securely.
(2) Verify the V3 harness does not droop
downward.
8. Antenna Wire Installation.
(a) Using a small foam tape, secure the GRAY
Antenna wire to the inside surface of the
upper dash cover as shown. (Fig. 8-1)
9. Warning Label and Key Tag Installation.
(a) Using household Windex, clean the inside
surface of the front door windows.
(b) Place the warning label on the inside surface
of the front door's windows as shown.
(Fig. 9-1)
(1) Use a piece of clear adhesive tape to lift
the labels off of their protective backing
sheet.
(2) Do not touch the adhesive surface of the
warning labels.
(3) Line up the labels properly and place on
the glass once; do not use a label that was
pulled off the glass.
Fig. 9-1
10mm
Warning
Label
Lineup with
Bottom of
Window Etching
Fig. 8-1
Small Foam Tape
Antenna Wire
(Gray)
V3 ECU
V3 Harness
V3 ECU
Fig. 7-5
8P, 12P, 22P
Fig. 7-6
10mm Socket
Vehicle's Bolt
V3 ECU
V3 Harness