Specifications

SCION xB 2004 - BASS TUBE (BAZOOKA
®
)
Procedure
Page 6 of 15 pages
Issue: A 08/16/04
(a) If vehicle is equipped with a rear cargo mat
(PN: PT206-52043-02) remove the cargo mat
at this time (Reference Step 9 (a))
(b) Remove the rear cargo panels from vehicle,
by unlocking the 3 locking knobs, and lifting
both panels out of the vehicle.
(c) Place the rear left (drivers side) panel onto a
safe, & stable surface, where drilling is safe.
(d) Place the drill template onto the rear drivers’
side cargo panel, aligning it over to the far
right side profile of the panel. (Fig. 8-1)
(e) Using the 5/16” drill bit, drill the 4 allotted
holes into the rear panel.
(1) Make sure the holes are drilled straight.
(2) Clean the cargo panel from any shavings
or drill debris.
(3) If vehicle is equipped with the rear cargo
mat, DO NOT PROCEED to the next
step. Proceed to Step 9 (a) at this time, to
prepare the rear cargo mat. If vehicle is
not equipped with rear cargo mat,
proceed to the next step (Step 8 (f))
(f) Starting on the 2 forward holes, place two (2)
M6 x 30mm bolts through the two outside
holes of the top mounting plate, (through the
pre-punched cargo mat, if equipped), through
the cargo panel, & into the threaded backing
plate, located underneath the panel. (Fig. 8-2)
(1) If the vehicle is NOT equipped with a
rear cargo mat, use the (2) M6 x 25mm
bolts on the 2 forward holes.
(2) Position the “curled” side of the top
mounting plate as shown in Fig. 8-3.
(g) On the rear 2 holes, place two (2) M6 x
30mm bolts through the two outside holes of
STOP
M6x30mm
or
M6x25mm*
Top Mounting
Plate
Cargo Mat*
Cargo Panel
Backing Plate
Rear of Vehicle
M6x30m
m
Top Mounting
Plate
Cargo Mat*
Cargo Panel
Backing Plate
Fig. 8-2
Fig. 8-3
Fig. 8-1
Fig. 8-4
STOP
STOP
STOP