Specifications

SCION xB 2004 - BASS TUBE (BAZOOKA
®
)
Procedure
Page 4 of 15 pages
Issue: A 08/16/04
7. Route Wire Harness
(a) Starting underneath the passenger foot-well,
route the T-Harness portion of the wire
harness through the opening above the center
reinforcement rod as shown in Figure 7-1.
(b) Reaching through the radio opening, pull the
T-Harness connector from the backside of
the dash, while advancing the wire harness
from underneath the passenger foot-well.
(Fig. 7-2)
(c) Using one (1) 7” wire tie, secure the wire
harness behind radio, onto an existing
vehicle wire harness. (Fig. 7-3)
(d) Using six (6) 7” wire ties, secure the wire
harness at the 6 highlighted points. (Fig. 7-4)
(1) Be sure the wire tie locations are far from
moving parts or sharp edges. Ensure that
the wire harness is tied tight enough to
prevent it from moving or vibrating.
(2) Using the diagonal cutter pliers, clip the
seven (7) 7” wire ties.
(e) Route the wire harness towards the rear of
the vehicle, across the passenger front door
well, behind the B-Pillar and across the
passenger rear door well.
(1) Using the vehicle accommodated clips,
secure the wire harness using the 4”wire
ties. Use the included wire ties when
vehicle clips are not present, to ensure
that the wire harness is not loose.
(f) Remove the rear bench seat by pulling
upwards on each corner, to release the two
(2) mounting clips. (Fig. 7-5)
Fig. 7-1
Fig. 7-5
Fig. 7-4
Fig. 7-3
Fig. 7-2
STOP