Specifications

SCION xB 2004 - BASS TUBE (BAZOOKA
®
)
Procedure
Page 3 of 15 pages
Issue: A 08/16/04
4. Remove Radio
(a) With the center IP removed, use a #2 Philips
Screwdriver to remove the four (4) screws
from the radio bracket. (Fig. 4-1)
(b) Pull out the Radio and carefully disconnect
the connectors located behind.
(1) A NRT may be used to release difficult
connectors from the radio.
(2) Carefully place Radio on a protected
surface (i.e. blanket)
5. Disassemble Glove Compartment
(a) Open the glove compartment latch, and
remove the storage cup. (Fig. 5-1)
(b) Press the outside edges of the glove
compartment inwards, to release. (Fig. 5-2)
(1) Place glove compartment and storage cup
on a protected surface (i.e. blanket)
6. Disassemble Passenger Front & Rear Scuff
Plates, Passenger Kick Panel, & B-Pillar
Panel
(a) Using a NRT, remove passenger front scuff
plate by carefully pulling upward. (Fig. 6-1)
(b) Remove passenger kick panel by removing
the plastic screw (located near firewall) &
pulling out the kick panel. (Fig. 6-2)
(c) Using a NRT, release the bottom portion of
the B-Pillar panel and remove panel.
(d) Using a NRT, remove rear passenger scuff
plate by carefully pulling upward. (Fig. 6-3)
(1) Place kick panel, and all scuff plates on a
protected surface (i.e. blanket)
STOP
STOP
STOP
Fig. 4-1
Fig. 5-1
Fig. 5-2
Fig. 6-3
Fig. 6-1
Fig. 6-2