Specifications

SCION xB 2004 - BASS TUBE (BAZOOKA

)

Procedure

Page 2 of 15 pages

Issue: A 08/16/04

Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this

accessory should follow approved guidelines to ensure a quality installation.

These guidelines can be found in the "Accessory Installation Practices" document.

This document covers such items as:-

• Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).

• Safety (eye protection, rechecking torque procedure, etc.).

• Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).

• Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).

Please see your Toyota dealer for a copy of this document.

1. Pre-installation Precautions

(a) Use Seat & Floor Protectors and Fender

Covers/Blankets to avoid damage to surfaces.

Operator Safety Warning (if applicable.)

2. Battery Disconnect

(a) NOTE: Be sure to open the rear hatch,

PRIOR to disconnecting the battery.

(b) Remove the NEGATIVE (-) battery terminal

using a 10mm socket before any disassembly

starts. (Fig. 2-1).

3. Disassemble Center Instrument Panel (IP)

(a) Starting with the center portion of the center

IP, pull out the three (3) climate control

knobs (Fig. 3-1)

(b) Using the #2 Philips Screwdriver, remove the

2 screws behind the right & left side climate

control knobs. (Fig. 3-2)

disconnect the connectors located behind.

(Fig. 3-3 & 3-4)

(1) A NRT may be used to remove difficult

connectors from center IP.

(2) Place center IP, Pillars (and all interior

panels) on a protected surface (i.e.

blanket)

STOP

Fig. 3-2

Fig. 2-1

Fig. 3-1

Fig. 3-4