Owner`s manual

SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 14 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
7. Plug in the V3 harness’ white 1P connector to
the vehicle harness’ white 1P connector.
(Fig. E−7)
i. Verify the connectors are plugged in
securely.
8. Secure the 1P connectors to the vehicle
harness with one medium wire tie. (Fig. E−7)
9. Secure the V3 harness to the vehicle harness
with two medium wire ties. (Fig. E−7)
10. Route and secure the V3 harness to the
reinforcement with two large wire ties.
(Fig. E−8)
11. Route and secure the V3 harness to the vehicle
harness with three medium wire ties above the
passenger side cowl area. (Fig. E−8)
12. Locate and disconnect the white 14P connector
from the passenger side cowl area.
(Fig. E−9)
Fig. E−9
Side Cutter
14P (White)
STOP
V3 Harness
14P (White)
Fig. E−7
Side Cutter
Medium Wire
Ties (x3)
V3 Harness
1P (White)
Fig. E−8
Side Cutter
Large Wire
Ties (x2)
Medium Wire
Ties (x3)
V3 Harness
Reinforcement