Owner`s manual

SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 13 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
4. Route and secure the V3 harness to the
vehicle’s bracket with one medium wire tie
behind the center cluster. (Fig. E−4)
i. Pass the wire tie through the hole of the
vehicle’s bracket.
5. Route and secure the V3 harness to the vehicle
harness with one medium wire tie in the glove
area. (Fig. E−5)
6. Locate the vehicle harness’ white 1P connector
and remove the tape from the 1P connector in
the passenger side glove box area. (Fig. E−6)
Fig. E−5
Side Cutter
V3 Harness
Medium Wire Tie
1P (White)
Fig. E−6
1P (White)
Tape
Vehicle’s 1P (White)
V3 Harness
Fig. E−4
Side Cutter