Owner`s manual

SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 12 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
E. Wire Harness Installation (Continued)
1. Locate the vehicle’s brace in the driver’s side
behind the center cluster. Attach one large
foam tape to the brace. (Fig. E−1)
i. Verify the edge of the brace is covered.
2. Locate the vehicle’s brace in the driver’s side
behind the center cluster. Attach one large
foam tape to the brace. (Fig. E−2)
i. Attach tape to both ends of the bracket.
ii. Verify the edge of the brace is covered.
3. Route and secure the V3 harness to the vehicle
harness with two medium wire ties behind the
center cluster in the drivers side. (Fig. E−3)
Fig. E−1
Large Foam Tape
Vehicle’s Brace
Fig. E−2
Large Foam Tape
Vehicle’s Brace
Fig. E−3
Side Cutter
Medium Wire
Ties (x2)
V3 Harness