Instruction Manual

6
Setting up
Place the unit on an even, stable, clean, nonslip, dry and fireproof surface.
Keep at least 10 cm of open space on the front and rear side.
Do not set up the device close to heat sources and do not expose to sun light.
Ensure the pump plug is security fixed without any external circulation。
Filling and draining
Connect the inlet and outlet to the external reactor (if needed).
Attention: Ensure the drain valve is fully closed before Filling.
Remove the bath cover before Filling.
Monitor the liquid level during Filling.
Attention: Do not empty the bath while it is still hot, there is a risk of burning! Only drain
with a suitable draining hose and container.