Instruction Manual

4
The device can only run without any malfunction or damage.
As the operator of the device, any malfunction or damage found, please: Switch
off the device.
Pull the plug of the device.
Contact us for trouble shooting or repairing.
Note：
Place the unit on an even, stable, clean, nonslip, dry and fireproof surface.
The bath may be filled with flammable materials. Fire hazard!
Recommended fluids only, chemical dangers may occur, depending on the bath
medium.
Prevent water getting into hot bath oils.
The safety temperature limit must always be set to at least 25C lower than the flash point
of the fluid used.
Check the filling level of the bath fluid at regular intervals. The pump and heater must
always be completely covered with bath fluid.
Risk of burning caused by vapor or hot water at the outlet of the cooling coil.
The formation of explosive mixtures is possible if the ventilation is
inadequate.