User guide

7
MS-(H)-Pro Digital（Hotplate）Magnetic Stirrer
5.2 Display
T e m p S t i r
℃
R e m o t e
S e t
Probe H o t CBA
E r r
Real value
Rated
v a l u e
Temperature S t i r
Error
S e t
Mode
HotPlatewar
ning
External
probe
Remote
control
Figure 4
Characters Descriptions
Temp and ℃
Display temperature when the heating function is
switched ON.
Stir
Display stirring state when the stirring function is
switched ON.
Mode
Display the setting mode in order of A, B and C
after pressing mode key.
Set Press setting key to set function, and display Set characters.
Hot
Display hot warning if the heating plate temperature is
above 50℃ after switching OFF the heating function.
Probe Di
splay when using external probe.
Remote Display in case of remote control.
Err Display in case of error happening.
Rated value 、
Real value
Display value in case of heating or stirring function
switching ON.
Table 3
Note:
If both heating and stirring functions have been
started at the same time, the display of function
“heating” always has higher priority. If in this
case speed is changed via the stirring knob, it
display stirring speed and reverses to temperature
in the duration of 5 seconds.
6 Initialization
6.1 Initializing sequence
• Turn on instrument by the power switch.
• The “Heat” and “Stir” LEDs and the LCD display
flash about 3 times.
• LCD displays the workplate
,
s safe temperature limit in
“SAFE xxx°C”.
• LCD displays residual heat warning “rES On/OFF”.
• LCD displays stirring bar breakaway monitoring “br On/
OFF”.
• LCD displays operating modes(A、B、C).
• LCD displays the “Probe” characters in case of
connecting with external temperature sensors.
6.2 Default settings
MS-(H)-Pro is supplied with the following default settings