Manual

6
MS-H(M)-S10 10-Channel Analog (Hotplate) Magnetic Stirrer
LED Power
When the device is switched ON, the
LED power is lit.
Mains switch Switch ON or OFF.
Table 2
6 Operation
• Ensure the temperature control knob and the speed Control
knob at the lowest position .Put the device on the stable and
safe place and plug in the mains power.
• Turn ON the power switch and LED power is lit.
• Turn the speed control knob to set the rated rotary speed in
the safe spee
d limit from 0 to 1100 rpm.
• Turn the temperature control knob to set the rated
temperature in the safe limit from room temperature to
120℃(MS-H-S10).
• The device begins to work.
Note:
If there is any apparent damage to the system,
please do not plug it into the power line.
7 Faults
• If a unit fault happens, please power down the instrument.
• Switch ON the unit again.
• The stirring function will continue to operate at the speed
set point before the fault took place.
• The heating function will continue to operate at the set
point before the fault took place.
• If the pr
oblem is not solved, please contact the technical
service center.
8 Maintenance and Cleaning
• Proper use and maintenance can keep instruments working
in a good state and lengthen its life time.
• Be careful not spray the cleanser into the instrument when
cleaning.
• Unplug the power line when cleaning.
• Only use cleanser that we advised as below:
Dyes Isopropyl alcohol
Construction
materials
Water containing tenside / isopropyl alcohol
Cosmetics Water containing tenside / isopropyl alcohol
Foodstuffs Water containing tenside
Fuels Water containing tenside
Table 3
• Other method ,please contact manufacturer.
• Wear the proper protective gloves during cleaning of the
instrument.